Daily Usage Instructions

1. Pre-Print Inspection

Before every print, check the build platform and material tray for any residue. Failure to do so may result in crushing or damaging the oxygen-permeable membrane.

2. Cleaning the Material Tray

When cleaning the tray, use a silicone spatula to gently lift residue before picking up the thin flakes. Never use tweezers or other sharp objects to touch the oxygen-permeable membrane.

3. Handling Failed Prints

If a print is incomplete or falls off, there will be residue left in the tray. You must clean this out immediately (refer to step 2).

4. Material Recycling

Any leftover material in the tray must be passed through a filter net before it can be reused.

5. Oxygen Preparation

Always turn on the oxygen concentrator 10 minutes before starting a print.

6. Environmental Cleanliness & Maintenance

Keep the machine and the area around the material tray clean. If you see solidified wax inside the tray, clean it with alcohol before printing.

Note

The oxygen-permeable membrane cannot be wiped with alcohol. First, use a cloth to absorb the material, then use a lens wipe (spectacle wipe) to gently clean it.

7. Tray Security

The screws on both sides of the material tray must be gently tightened before printing.

8. Optical Maintenance

The light source lens must be cleaned of dust regularly; otherwise, the light projection and print quality will be affected.

9. Component Alignment

When installing or removing the material tray, ensure the oxygen inlet/outlet is fully aligned and seated at the bottom. Any misalignment or looseness will cause unstable air pressure.