3D Printer Installation Process

Due to potential vibrations during transportation, the entire installation process must be performed by our professional engineers to prevent electrical faults. Customers may refer to the following workflow to verify and inspect the installation:

1. Preparation: Gather the printer, oxygen concentrator, material tray, build block, printer power cable, oxygen concentrator air hose, and network connection equipment. Place all items at the designated installation site.

2. Stabilization: Secure the four corners of the printer to ensure it is level and fixed.

3. Circuit Inspection: Check all internal wiring and connections for any looseness (Performed by installation engineer only).

4. Network Setup: Connect the network equipment (optional).

5. Power Connection: Plug in the main printer power cable. If the local power supply is unstable, a Uninterruptible Power Supply (UPS) must be configured based on the environment.

6. Material Tray Installation: Identify the front of the material tray (the side without air nozzles). Push it into the slot until it reaches the bottom and feels secure. Insert the air hoses from both sides of the Z-axis arm into the nozzles on the back of the tray first, then tighten the screws or knobs on both sides clockwise.

7. Build Block Installation: Insert the build block into the Z-axis arm. Once seated, loosen the large screw on the upper Z-axis arm, as well as the four set screws and three nut-fastened screws on the build block. This prepares the unit for the zeroing process (refer to "Part 3: Control Software Usage – Platform Zeroing").

8. Airflow Meter Reset: Ensure the airflow meter on the bottom left of the printer’s rear panel is set to zero. If not, turn the knob clockwise until tightened.

9. Verification Card: Insert the digital verification card downward into the circular black slot located at the bottom rear of the printer.

10. Oxygen Concentrator Startup: Connect the oxygen concentrator to power and turn it on. Open the airflow knob on the concentrator. Once the indicator shows an oxygen concentration above 95% (with no red alarm lights), insert the air hose into the intake port on the left rear of the printer and turn on the printer's power switch.

11. Temperature Setting: Set the temperature gauge on the back of the printer to 40°C~.

12. Pressure Adjustment: Monitor the airflow pressure gauge on the back-left of the printer. Slowly turn the knob until the value fluctuates between 0.50 and 0.6.

13. LAN Configuration: Configure the local area network for the workspace (optional).

14. Software Launch: Turn on the computer on the front panel and open the control software. If the software starts without any error messages, the installation is successful.